Archive for October, 2012
Finally !!!!
by Moogle on Oct.05, 2012, under 3d printing, Reprap Prusa
It prints good!
From Minecraft to real life!
by Moogle on Oct.02, 2012, under 3d printing, Reprap Prusa
This was a spawn that I made in minecraft
the sphere is 1 block thick
more prusa prints
by Moogle on Oct.01, 2012, under 3d printing, Reprap Prusa
Safety switch mount location mount ideas
bolt to the end?
Holes in bottom can be used for a clamp or snap in mount maybe?
Bolt to the bar?
less tempting to hit bar mount?
block the ramps fan mount?
Make a custom z stepper mount that can be bolted to?
maybe attach to the extra bit of rod?